|
PROJECT
CAR
MODIFICATIONS
| PICTURES | VIDEOS | ACHIEVEMENTS
Right click on the link and "Save Target As..."
Featured
Video

1992 Maxima runs 12.8 @ 104mph versus a Lexus
SC300
at Kinston Strip Drag in Kinston, NC on Nov 9th, 2007.
This video speaks for itself. I apologize for the bad resolution.
(Added on 11/11/07)

The
NWP 92 Maxima SE 0-80mph with slicks and 75 shot!
This video is taken on the street with 22" Mickey Thompson
Drag Slicks
and 75 shot (Added on 11/7/07)
|

Burnout in a Straight Line
(Added on
9/30/06)
Here is me stalling it up a little
bit, then letting
it rip all the way through first gear. It left two long
streaks on the pavement!
|

75
shot Nitrous Run from 25-85mph (Added on
9/13/07)
Here is the NWP Engineering Project Maxima with the 75 shot.
I sprayed from a roll in 1st gear at 25mph and didn't let off until
I made the 2-3 shift! The tires spun lightly through the entire
1st gear as soon as I sprayed at 25mph.
|
|

0-70mph on a cool night
(Added 9/22/06)
I had to take this video
since it's the first time
I've felt my car this fast since the Spring when
I ran 13.7s at the drag strip. As soon as I got on the
gas, it spun more than I expected, so I backed off
and got right back into it and proceeded to bark 2nd gear. :)
|

Small burnout then bark into 2nd
gear (Added 9/23/06)
Here is an exterior
video of me going through 1st gear and into 2nd.
|
This section was added on 11/8/05
3rd
gear pull with cutout closed (1.12MB SQ)
This is a 3rd gear pull
from about 80mph to 115mph. I was just testing out the camera on low
quality and I figured I'd put these videos up here.
Identical
3rd gear pull with cutout open (966KB SQ)
This is also a 3rd gear
pull from about 80mph to 115mph. But with the cutout open.
This was all done on my way back from FL to NC.
This video section
was added on 11/11/04
|

Me
versus a new Volvo S60 (5.57MB)
This was at Moroso Motorsports
Park in West Palm Beach, FL. I ran 14.90 with a 2.18 60' against
this Volvo that had a 3.3 60' and a mid 17 second 1/4 mile. I had a
great launch without any loss of traction.
|

Solo
run at the end of the night (4.24MB)
This was also at Moroso.
I ran 14.95 with a 2.21 60'. I wasn't able to heat my drag
radials up enough on the burnout and that caused me to chirp off
the line.
|
|
This video section
was added on 10/11/04

Me
versus a 93 Mustang 5.0 5spd with intake, exhaust, and 200 lb weight
reduction (4.71MB)
This is a race against Andy, Dmontzsta's
coworker, at the track in Carlsbad, CA on 3/20/04. You see I have
him beat at half track, but he pulled on me shortly after and got me by a
car length. I ran 14.67 @ 94.41 mph to his 14.23 @ 96.25 mph.
I beat him on the tree too. |

Me
versus a 12 second Mustang 5.0 with nitrous (4.87MB)
This is another race at Carlsbad, CA on 3/20/04.
You'll see that I have this guy whooped in the 60 foot. Haha, but shortly
after that, he proceeded to pass me. I ran 14.67 @ 94.57 mph to his
12.49 @ 118mph. I did a 2.21 60' to his 2.26. |

Me
versus a VQ 5spd with intake (673KB)
This is at a track meet in Fayetteville, NC in
2002. I had to give a VQ 5spd a slice of the VE power. I think I ran
15.3 to his 15.4. Nobody in NC knew what my car was capable of until
they saw it for the first time at this race. |

Me
versus a Mustang GT in Fayetteville, NC (620KB)
This is the same 2002 track meet. I was
only running 15.2s back then. So, of course the Stang beat me. |

Me
versus some slow Civic in Fontana at the California Motorspeedway
(1.40MB)
This is 3/9/03 while I was running 15.1s that
day. It's only the first 60 feet, but you can tell who won that
race. |
|
Exhaust Cutout
Videos
This video section was added on 6/30/04
2.5"
Electric Cutout closed and open comparison (4.14MB HQ 15 sec)
2.5"
Electric Cutout open from 0 - 55mph (3.31MB HQ 11 sec)
Torque Converter &
Track wheels Videos
All of the videos below
show the tachometer as I launch the car. They are done without
stalling up the motor prior to launch. There was no torque brake
done at all. The short pause or hesitation that you may notice is
due to traction loss on the launch.
0 to 70mph WITHOUT high stall torque converter or track wheels (750KB SQ)
0 to 70mph
WITH high stall torque converter - No track wheels (3.13MB HQ)
0 to 80mph
WITH high stall torque converter - No track wheels (3.67MB HQ)
0 to 70mph WITH high stall torque converter AND my 195/45R15 Toyo T1-S
track wheels (3.37MB HQ)
0 to 70mph WITH high stall torque converter AND my 195/45R15 Toyo T1-S
track wheels (3.30MB HQ) (My favorite)
MODIFICATIONS
| PICTURES | VIDEOS | ACHIEVEMENTS
HOME
| SERVICES
| PRODUCTS
| PROJECT CAR | CONTACT US
Copyright © 2007 by NWPEngineering.com.
All rights reserved.
|